Motorcycle Master Cylinder with Lever

Throttle Assembly, Internal Throttle, Twist Clutch, etc. 3 Comments

This super small motorcycle master cylinder with lever was specifically designed to be used in conjunction of our Weld On Motorcycle Hand Controls, De Luxe Retro Cable Motorcycle Hand Controls Aluminum and Brass and De Luxe Retro Cable Motorcycle Hand Controls All Aluminum, so they can be used as brake or hydraulic clutch motorcycle levers. Machined out of billet aluminum, this motorcycle master cylinder with lever can be easily hidden on your custom chopper or bobber for a super-clean look. It can be welded under the seat, under the tank or in any other place hidden or not. This 9/16″ bore chopper motorcycle master cylinder can be used with single two piston brake caliper, four piston brake caliper, six piston brake caliper or dual two piston brake calipers. Mounting bracket will need to be fabricated and welded to the desired location.

 

master cylinder with lever for weld-on hand controls

remote master cylinder with lever

3 Responses to “Motorcycle Master Cylinder with Lever”

  1. Remote Reservoir for Master Cylinders says:

    […] This remote fluid reservoir can easily be hidden anywhere on you custom motorcycle, chopper or bobber. It works great in conjunction with our Motorcycle Master Cylinder with Lever. […]

  2. S.O.B Cycles says:

    I read that you recommend DOT4 brake fluid, but will DOT5 work without compromising the seal integrity?

  3. eurocomponents says:

    Thank you for your interest in Eurocomponents’ motorcycle master cylinders.

    All the seals are designed to be used with non-silicon based oils: DOT 4, DOT 5.1 or DOT 5.2.
    So you shouldn’t use DOT 5.

    On the other hand 90% of our customers use DOT 5 brake fluid. In some cases we have seen seals had to be replaced after 1 year, in other cases there were no problems at all. We came to the conclusion that this largely depends on the brand of oil used, but we have not able to identify the “good” brands.

    Therefore we are sticking with the seals’ manufactuerer recccomendation not to use DOT 5.

    Please let us know if we can be of further help.
    Thank you and have a good day.

    Lorenzo
    …………………………………………………………
    Eurocomponents, Inc.
    1368 North US 1 – Suite 402
    Ormond Beach, FL 32174 (USA)
    Phone 386-868-0696
    Fax 386-274-5733
    http://www.eurocomponentsUSA.com

Leave a Reply

Currently you have JavaScript disabled. In order to post comments, please make sure JavaScript and Cookies are enabled, and reload the page. Click here for instructions on how to enable JavaScript in your browser.